KiLa

[KiLa]

To answer my own question:

1. Right click control and select MIDI Learn
2. Adjust the amount slider, in modulation editor, to specify how much each MIDI CC message changes the value
3. Adjust the offset slider, in modulation editor, to set the ‘start’ value for the controlled value

[KiLa]

Hi, I probably didn’t understand exactly what you said, but I also found the ‘assign to macro’ solution, and then using Ratio slider in Edit page for the macro, I can control how much one CC increases the value. It works fine, except: MIDI CC 0 is mapped to value 0, and I would like to map the MICI 0-127 to…99.5-99,7..ish.

-k

[KiLa]

Searched it from the tree view..Thank you!

[KiLa]

Thx Simon, problem was on me end..between the monitor and the chair 😀

[KiLa]

Thx Simon. I was kinda thinking that it had to be something like that. Haven’t read the entire manual yet, but what does the Pitch Bend modulator actually do? It doesn’t seem to have any controls, and i cannot remove or power off it: it seems that both – Pitch Ben and Analog ADSR – are required in order to cancel the sound after release.

 

-k